TP-Link WR941N 刷 OpenWrt
source link: https://fann.im/blog/2012/11/29/tp-link-wr941n-flash-openwrt/
Go to the source link to view the article. You can view the picture content, updated content and better typesetting reading experience. If the link is broken, please click the button below to view the snapshot at that time.
TP-Link WR941N 刷 OpenWrt
Nov 29, 2012
硬件版本 TP-Link WR941N V4/V5 00000000,软件版本 3.11.7 build 100723,从 OpenWrt trunk 下载对应固件 openwrt-ar71xx-generic-tl-wr941nd-v4-squashfs-factory.bin。其他型号参考 Table of Hardware 下载固件。
登录路由器升级固件,待路由自动重启后 telnet 192.168.1.1
连上路由器,passwd
设置密码,之后就可以通过 ssh [email protected]
登录路由器。
OpenWrt 默认没有开启无线网络,参考 TP-Link TL-WR941ND 手动修改 vi /etc/config/wireless
: (修改之前最好备份一下配置文件)
config wifi-device radio0
option type mac80211
option channel 11
option hwmode 11ng
option path 'pci0000:00/0000:00:00.0'
option htmode HT20
list ht_capab SHORT-GI-40
list ht_capab TX-STBC
list ht_capab RX-STBC1
list ht_capab DSSS_CCK-40
# REMOVE THIS LINE TO ENABLE WIFI:
# option disabled 1 (删除或注释这一行)
config wifi-iface
option device radio0
option network lan
option mode ap
option ssid OpenWrt
option encryption psk (默认没有加密,修改为 psk)
option key xxxxxxxxx
重启路由网络:
/etc/init.d/network restart
配置 PPPoE,vi /etc/config/network
:
config interface 'wan'
option ifname 'eth1'
option proto pppoe
option username 1234567
option password 7654321
option macaddr xx:xx:xx:xx:xx:xx (克隆路由器网卡地址)
再次重启路由网络进行拨号。
安装 LuCI web 界面,这样就可以在浏览器操作路由:
opkg update
opkg install luci
/etc/init.d/uhttpd enable
/etc/init.d/uhttpd start
现在就可以通过 http://192.168.1.1
修改路由器配置。
如果网络修改失败不能 ssh 登录,可以进入安全模式恢复:
路由上电时,灯会全亮一下,这时你要全神贯注了,当sys灯再次亮时,要立刻按reset2-3秒,然后你就会发现sys灯快闪了。这说明,安全模式成功了!
本机 IP 改为 192.168.1.5,telnet 192.168.1.1
连上,然后 firstboot
恢复。
Was this page helpful?
Recommend
About Joyk
Aggregate valuable and interesting links.
Joyk means Joy of geeK