Development - [13.04.22] G998B I Dr.Ketan ROM I OneUI 4.1 I OneUI 3.1 | Page 99...
source link: https://forum.xda-developers.com/t/13-04-22-g998b-i-dr-ketan-rom-i-oneui-4-1-i-oneui-3-1.4247357/page-99#post-86992979
Go to the source link to view the article. You can view the picture content, updated content and better typesetting reading experience. If the link is broken, please click the button below to view the snapshot at that time.
Development [13.04.22] G998B I Dr.Ketan ROM I OneUI 4.1 I OneUI 3.1
Thread starter
Start date
hello.
does the rom have a good effect on battery consumption?
Are there any problems when using bank applications?
The battery is same like the Stock and i Got Problem s With my Bank App i uninstall magisk then IT works
Reactions: almora9
DestroSenakai
New member
(Edited after successful installation)
I have rooted my phone and installed your
Custom rom
My first mail was sent while i was still on the stock rom
The latter mail was sent with your custom rom
I have subscribed to premium tweakspro
Please im eagerly waiting to try your development on my s21 ultra
(Im quite new to all this so please dont mind me )
My telegram username is @MuhammadSenakai
(Paypal id [email protected])
blackbuster14
Member
Anyone have some issue? My refresh rate note adaptive and not adjust to 60hz when device idle. It cause drain my battery.
Second question, how to back to stock ROM? I can't flash with odin, it say "Sw Rev Check Fail Bootloader 0x5 binary 0x4" and Odin stuck on ldfw
View attachment 5625103View attachment 5625105
Make sure youre flashing the latest firmware
blackbuster14
Member
Make sure youre flashing the latest firmware
I flash the latest firmware from my region is G988BXXU4 whereas Dr. Ketan ROM use G988BXXU5
kimdonghwan
Member
i'm so sick with stock bloatwares..most of them cannot be disabled..
I flash the latest firmware from my region is G988BXXU4 whereas Dr. Ketan ROM use G988BXXU5
So download the latest one either from the post here in XDA or use frija and download the DBT or BTU build, It should be CVDD firmware. The reason you're getting that error is you're trying to flash an older binary version firmware than the one you're already using from Dr Ketans rom.
CVDD - May | GALAXY S21 Ultra 5G | Official Firmware (SM-G998B) | 2nd May
I updated magisk as per the prompts, hot phone and very bad battery drain, rolled back and the issues are gone....
Which version did it update to? Curious, as just opened the app up and I'm still on 24.3
Which version did it update to? Curious, as just opened the app up and I'm still on 24.3
Don't pay attention sorry, to busy trying to fix the overheating and lag issue
ChangeLog S12
- Based on G998BXXU5CVEB Jun 2022 security patch OneUI 4.1
- ROM Tool on essential fix auto setup zygisk including SafetyNet fix (Read setting up ROM below)
- CSC files for OXM group updated : Read Important Notes below for more details.
- In case clean installing ROM
- On first boot, open magisk and complete the additional setings if asked for, else exit the magisk app. (Don't setup any option in magisk now)
- Then open ROM Tool, Apply essential fix and Reboot,
- After reboot you can check SafetyNet and should be passed. You can use this app from playstore or This from Github to check SafetyNet (Applying ROM Tool Essential fix will offer to install this app)
- Now you can further setup ROM a per your liking. Also MagikHide is Configure Denylist now and available under Magisk Settings.
- Since A12 Stable Magisk not working and new Magisk doesn't have buil-in Module repo, You can get standalone module manager from here For more details and queries about new magisk ref this (Applying ROM Tool Essential fix will offer to install this app)
- Clear ROM Tool data
- Before installing ROM, uninstall all magisk modules and Magisk manager from app drawer
- After ROM installation, update Magisk from installed stub
- Then Follow above instruction for clean installation
- In case you have any issue after dirty install, don't post queries on thread, we don't support dirty install, simply go with clean install.
IMPORTANT NOTES :
- We recommended to flash Stock firmware before flashing this ROM if you are on too old base or on other ROM, If not full, at least flash Home_CSC*.tar.md5 file from stock firmware with CSC tab of Odin. This is specifically for Non OXM group of CSC (To check your CSC group, Dial *#1234#. If CSC part doesn't starts with G998BOXM your are on Non OXM group of CSC
- For OXM group of CSCs, (If your CSC part starts with G998BOXM) CSC files are included (about 131 CSCs) in ROM setup file, You can see complete list of available CSC in aroma installer. You must select to flash CSC option if your csc is part of it. This will update CSC files to same base.
- New base have updated bootloader so if you are running previous base, you must needs to update Bootloader & Modem else device won't boot. BL and Modem included in ROM zip with separate instructions.
- Clean Install is recommended always.
- Don't Install any module related to SafetyNet Fix/Busybox/Multidisabler etc, Everything is included in ROM itself.
ROM Features (XDA Version)
Installation Guide : (File included in ROM zip itself)
Requirement : G998B with TWRP installed
Download and extract zip - It have all required files. Read Installation file and follow to ther letter.
Known Bug/Tips/Fix
Download : DrKetanROM.com
PS : This is a fully customized ROM and for end users only, ROM or any part of ROM not allowed to redistribute,modify or to use as base to prepare new ROM.
STATUS : Testing
MichelKastro
Member
Testing S12 Now!
ChangeLog S12Important Instructions for setting up ROM (NEW)
- Based on G998BXXU5CVEB Jun 2022 security patch OneUI 4.1
- ROM Tool on essential fix auto setup zygisk including SafetyNet fix (Read setting up ROM below)
- CSC files for OXM group updated : Read Important Notes below for more details.
- In case clean installing ROM- In case dirty install (You can try if you are on DrKetan ROM previous version but we DO NOT RECOMMENDED)
- On first boot, open magisk and complete the additional setings if asked for, else exit the magisk app. (Don't setup any option in magisk now)
- Then open ROM Tool, Apply essential fix and Reboot,
- After reboot you can check SafetyNet and should be passed. You can use this app from playstore or This from Github to check SafetyNet (Applying ROM Tool Essential fix will offer to install this app)
- Now you can further setup ROM a per your liking. Also MagikHide is Configure Denylist now and available under Magisk Settings.
- Since A12 Stable Magisk not working and new Magisk doesn't have buil-in Module repo, You can get standalone module manager from here For more details and queries about new magisk ref this (Applying ROM Tool Essential fix will offer to install this app)
PS : Plz don't install any other mods for SafetyNet, All queries related to Magisk/SafetyNet will be ignored if already explained above
- Clear ROM Tool data
- Before installing ROM, uninstall all magisk modules and Magisk manager from app drawer
- After ROM installation, update Magisk from installed stub
- Then Follow above instruction for clean installation
- In case you have any issue after dirty install, don't post queries on thread, we don't support dirty install, simply go with clean install.
IMPORTANT NOTES :TweaksPro version requires 4.0.1 or up (Old version may bootloop)
- We recommended to flash Stock firmware before flashing this ROM if you are on too old base or on other ROM, If not full, at least flash Home_CSC*.tar.md5 file from stock firmware with CSC tab of Odin. This is specifically for Non OXM group of CSC (To check your CSC group, Dial *#1234#. If CSC part doesn't starts with G998BOXM your are on Non OXM group of CSC
- For OXM group of CSCs, (If your CSC part starts with G998BOXM) CSC files are included (about 131 CSCs) in ROM setup file, You can see complete list of available CSC in aroma installer. You must select to flash CSC option if your csc is part of it. This will update CSC files to same base.
- New base have updated bootloader so if you are running previous base, you must needs to update Bootloader & Modem else device won't boot. BL and Modem included in ROM zip with separate instructions.
- Clean Install is recommended always.
- Don't Install any module related to SafetyNet Fix/Busybox/Multidisabler etc, Everything is included in ROM itself.
ROM Features (XDA Version)
Installation Guide : (File included in ROM zip itself)
Requirement : G998B with TWRP installed
Download and extract zip - It have all required files. Read Installation file and follow to ther letter.
Known Bug/Tips/Fix
Download : DrKetanROM.com
PS : This is a fully customized ROM and for end users only, ROM or any part of ROM not allowed to redistribute,modify or to use as base to prepare new ROM.
STATUS : Testing
I installed build s12 and I get messages "software problem detected".
TrevorAshley
Senior Member
Good day, can I link to the S12 jump? and then there is only S11 on mediafire
It's in Testing, link will be updated when released.
Darkpurple
Senior Member
It's in Testing, link will be updated when released.
Dr. How to join the test group?...
TrevorAshley
Senior Member
Dr. How to join the test group?...
Hi! Install Tweaks Pro to get notify & link to test builds & updates.
Top Liked Posts
-
Testing S12 Now!
ChangeLog S12- Based on G998BXXU5CVEB Jun 2022 security patch OneUI 4.1
- ROM Tool on essential fix auto setup zygisk including SafetyNet fix (Read setting up ROM below)
- CSC files for OXM group updated : Read Important Notes below for more details.
- In case clean installing ROM- On first boot, open magisk and complete the additional setings if asked for, else exit the magisk app. (Don't setup any option in magisk now)
- Then open ROM Tool, Apply essential fix and Reboot,
- After reboot you can check SafetyNet and should be passed. You can use this app from playstore or This from Github to check SafetyNet (Applying ROM Tool Essential fix will offer to install this app)
- Now you can further setup ROM a per your liking. Also MagikHide is Configure Denylist now and available under Magisk Settings.
- Since A12 Stable Magisk not working and new Magisk doesn't have buil-in Module repo, You can get standalone module manager from here For more details and queries about new magisk ref this (Applying ROM Tool Essential fix will offer to install this app)
- Clear ROM Tool data
- Before installing ROM, uninstall all magisk modules and Magisk manager from app drawer
- After ROM installation, update Magisk from installed stub
- Then Follow above instruction for clean installation
- In case you have any issue after dirty install, don't post queries on thread, we don't support dirty install, simply go with clean install.
IMPORTANT NOTES :- We recommended to flash Stock firmware before flashing this ROM if you are on too old base or on other ROM, If not full, at least flash Home_CSC*.tar.md5 file from stock firmware with CSC tab of Odin. This is specifically for Non OXM group of CSC (To check your CSC group, Dial *#1234#. If CSC part doesn't starts with G998BOXM your are on Non OXM group of CSC
- For OXM group of CSCs, (If your CSC part starts with G998BOXM) CSC files are included (about 131 CSCs) in ROM setup file, You can see complete list of available CSC in aroma installer. You must select to flash CSC option if your csc is part of it. This will update CSC files to same base.
- New base have updated bootloader so if you are running previous base, you must needs to update Bootloader & Modem else device won't boot. BL and Modem included in ROM zip with separate instructions.
- Clean Install is recommended always.
- Don't Install any module related to SafetyNet Fix/Busybox/Multidisabler etc, Everything is included in ROM itself.
ROM Features (XDA Version)
Installation Guide : (File included in ROM zip itself)
Requirement : G998B with TWRP installed
Download and extract zip - It have all required files. Read Installation file and follow to ther letter.
Known Bug/Tips/Fix
Download : DrKetanROM.com
PS : This is a fully customized ROM and for end users only, ROM or any part of ROM not allowed to redistribute,modify or to use as base to prepare new ROM.
STATUS : Testinguse LSposed - Firedds KIT - . but is limitedhello.
does the rom have a good effect on battery consumption?
Are there any problems when using bank applications?The battery is same like the Stock and i Got Problem s With my Bank App i uninstall magisk then IT works
Recommend
-
4
[08.10.21] [R] I N975F_DS I N976_B_N I Dr.Ketan ROM I OneUI 3.1 W ...
-
14
Top Liked Posts There are some issue in v2 ROM please fix it asap as we as a user want to ditch Samsung core ui and these are some basic issue which are useful for normal user. 1. Google p...
-
26
Top Liked Posts ChangeLog S03 Based on N986BXXU3EVA9 Feb 2022 security patch OneUI 4.0 SafetyNet Fix : Pre-Fixed again, No needs to apply two times. Read setting up i...
-
10
Development [06.04.22] S908E I S908B I S9080 I S908N I Dr.Ketan Magisk ROM I OneUI 4.1...
-
6
[ROM][10.0][OneUI 2.5][G930X/G935X/N930X/N935X]FloydQ V6.0 ...
-
49
[ROM][A515F] OneUI 4.1 [S20 Port] ---- ICBM r0M v.1 & Kernel ---- ...
-
3
[03.01.17] [SM-J120G] Dr.Ketan ROM I Jio VoLTE I PreRooted (Magisk) ...
-
3
Development [01.08.22] G998B I Dr.Ketan ROM...
-
7
Development [08.04.23] Full ROM System-RW (...
-
4
Top Liked Posts ChangeLog T08 Based on G998BXXU7EWE1 Android13 May 2023 security patch OneUI...
About Joyk
Aggregate valuable and interesting links.
Joyk means Joy of geeK